| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| Memory leak in ProFTPd 1.2.0rc2 allows remote attackers to cause a denial of service via a series of USER commands, and possibly SIZE commands if the server has been improperly installed. |
| The audit system in Linux kernel 2.6.6, and other versions before 2.6.13.4, when CONFIG_AUDITSYSCALL is enabled, uses an incorrect function to free names_cache memory, which prevents the memory from being tracked by AUDITSYSCALL code and leads to a memory leak that allows attackers to cause a denial of service (memory consumption). |
| Memory leak in NNTP service in Windows NT 4.0 and Windows 2000 allows remote attackers to cause a denial of service (memory exhaustion) via a large number of malformed posts. |
| In the Linux kernel, the following vulnerability has been resolved:
net: wwan: t7xx: fix potential skb->frags overflow in RX path
When receiving data in the DPMAIF RX path,
the t7xx_dpmaif_set_frag_to_skb() function adds
page fragments to an skb without checking if the number of
fragments has exceeded MAX_SKB_FRAGS. This could lead to a buffer overflow
in skb_shinfo(skb)->frags[] array, corrupting adjacent memory and
potentially causing kernel crashes or other undefined behavior.
This issue was identified through static code analysis by comparing with a
similar vulnerability fixed in the mt76 driver commit b102f0c522cf ("mt76:
fix array overflow on receiving too many fragments for a packet").
The vulnerability could be triggered if the modem firmware sends packets
with excessive fragments. While under normal protocol conditions (MTU 3080
bytes, BAT buffer 3584 bytes),
a single packet should not require additional
fragments, the kernel should not blindly trust firmware behavior.
Malicious, buggy, or compromised firmware could potentially craft packets
with more fragments than the kernel expects.
Fix this by adding a bounds check before calling skb_add_rx_frag() to
ensure nr_frags does not exceed MAX_SKB_FRAGS.
The check must be performed before unmapping to avoid a page leak
and double DMA unmap during device teardown. |
| A vulnerability, which was classified as problematic, was found in TechPowerUp GPU-Z 2.23.0. Affected is the function sub_140001880 in the library GPU-Z.sys of the component 0x8000645C IOCTL Handler. The manipulation leads to memory leak. It is possible to launch the attack on the local host. The exploit has been disclosed to the public and may be used. The vendor was contacted early about this disclosure but did not respond in any way. |
| Multiple denial-of-service vulnerabilities exist in the affected product. These issues can be triggered through various crafted inputs, including malformed Class 3 messages, memory leak conditions, and other resource exhaustion scenarios. Exploitation may cause the device to become unresponsive and, in some cases, result in a major nonrecoverable fault. Recovery may require a restart. |
| Missing release of memory after effective lifetime in the UEFI OobRasMmbiHandlerDriver module for some Intel(R) reference server platforms may allow a privileged user to enable denial of service via local access. |
| In Node.js, the `ReadFileUtf8` internal binding leaks memory due to a corrupted pointer in `uv_fs_s.file`: a UTF-16 path buffer is allocated but subsequently overwritten when the file descriptor is set. This results in an unrecoverable memory leak on every call. Repeated use can cause unbounded memory growth, leading to a denial of service.
Impact:
* This vulnerability affects APIs relying on `ReadFileUtf8` on Node.js release lines: v20 and v22. |
| On affected platforms running Arista EOS with BGP Link State configured, BGP peer flap can cause the BGP agent to leak memory. This may result in BGP routing processing being terminated and route flapping. |
| Redis through 8.0.3 allows memory consumption via a multi-bulk command composed of many bulks, sent by an authenticated user. This occurs because the server allocates memory for the command arguments of every bulk, even when the command is skipped because of insufficient permissions. NOTE: this is disputed by the Supplier because abuse of the commands network protocol is not a violation of the Redis Security Model. |
| Undici is an HTTP/1.1 client for Node.js. Prior to versions 5.29.0, 6.21.2, and 7.5.0, applications that use undici to implement a webhook-like system are vulnerable. If the attacker set up a server with an invalid certificate, and they can force the application to call the webhook repeatedly, then they can cause a memory leak. This has been patched in versions 5.29.0, 6.21.2, and 7.5.0. As a workaound, avoid calling a webhook repeatedly if the webhook fails. |
| A vulnerability was found in Undertow. This issue requires enabling the learning-push handler in the server's config, which is disabled by default, leaving the maxAge config in the handler unconfigured. The default is -1, which makes the handler vulnerable. If someone overwrites that config, the server is not subject to the attack. The attacker needs to be able to reach the server with a normal HTTP request. |
| A vulnerability in the Internet Key Exchange Version 2 (IKEv2) feature of Cisco IOS Software, IOS XE Software, Secure Firewall Adaptive Security Appliance (ASA) Software, and Secure Firewall Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to trigger a memory leak, resulting in a denial of service (DoS) condition.
This vulnerability is due to a lack of proper processing of IKEv2 packets. An attacker could exploit this vulnerability by sending crafted IKEv2 packets to an affected device. In the case of Cisco IOS and IOS XE Software, a successful exploit could allow the attacker to cause the device to reload unexpectedly. In the case of Cisco ASA and FTD Software, a successful exploit could allow the attacker to partially exhaust system memory, causing system instability such as being unable to establish new IKEv2 VPN sessions. A manual reboot of the device is required to recover from this condition. |
| Multer is a node.js middleware for handling `multipart/form-data`. Versions prior to 2.0.0 are vulnerable to a resource exhaustion and memory leak issue due to improper stream handling. When the HTTP request stream emits an error, the internal `busboy` stream is not closed, violating Node.js stream safety guidance. This leads to unclosed streams accumulating over time, consuming memory and file descriptors. Under sustained or repeated failure conditions, this can result in denial of service, requiring manual server restarts to recover. All users of Multer handling file uploads are potentially impacted. Users should upgrade to 2.0.0 to receive a patch. No known workarounds are available. |
| A vulnerability in the DHCP client functionality of Cisco Secure Firewall Adaptive Security Appliance (ASA) Software and Cisco Secure Firewall Threat Defense (FTD) Software could allow an unauthenticated, adjacent attacker to exhaust available memory.
This vulnerability is due to improper validation of incoming DHCP packets. An attacker could exploit this vulnerability by repeatedly sending crafted DHCPv4 packets to an affected device. A successful exploit could allow the attacker to exhaust available memory, which would affect availability of services and prevent new processes from starting, resulting in a Denial of Service (DoS) condition that would require a manual reboot.
Note: On Cisco Secure FTD Software, this vulnerability does not affect management interfaces. |
| A vulnerability classified as problematic has been found in FFmpeg up to 6e26f57f672b05e7b8b052007a83aef99dc81ccb. This affects the function audio_element_obu of the file libavformat/iamf_parse.c of the component IAMF File Handler. The manipulation of the argument num_parameters leads to memory leak. It is possible to initiate the attack remotely. The exploit has been disclosed to the public and may be used. The identifier of the patch is 0526535cd58444dd264e810b2f3348b4d96cff3b. It is recommended to apply a patch to fix this issue. |
| A vulnerability in the Internet Key Exchange Version 2 (IKEv2) module of Cisco Secure Firewall Adaptive Security Appliance (ASA) Software and Secure Firewall Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to trigger a memory leak, resulting in a denial of service (DoS) condition.
This vulnerability is due to improper parsing of IKEv2 packets. An attacker could exploit this vulnerability by sending a continuous stream of crafted IKEv2 packets to an affected device. A successful exploit could allow the attacker to partially exhaust system memory, causing system instability like being unable to establish new IKEv2 VPN sessions. A manual reboot of the device is required to recover from this condition. |
| A memory leak could occur when a remote peer abruptly closes the socket without sending a GOAWAY notification. Additionally, if an invalid header was detected by nghttp2, causing the connection to be terminated by the peer, the same leak was triggered. This flaw could lead to increased memory consumption and potential denial of service under certain conditions.
This vulnerability affects HTTP/2 Server users on Node.js v18.x, v20.x, v22.x and v23.x. |
| A vulnerability in the Internet Key Exchange Version 2 (IKEv2) feature of Cisco IOS Software, IOS XE Software, Secure Firewall Adaptive Security Appliance (ASA) Software, and Secure Firewall Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to trigger a memory leak, resulting in a denial of service (DoS) condition.
This vulnerability is due to a lack of proper processing of IKEv2 packets. An attacker could exploit this vulnerability by sending crafted IKEv2 packets to an affected device. In the case of Cisco IOS and IOS XE Software, a successful exploit could allow the attacker to cause the device to reload unexpectedly. In the case of Cisco ASA and FTD Software, a successful exploit could allow the attacker to partially exhaust system memory, causing system instability such as being unable to establish new IKEv2 VPN sessions. A manual reboot of the device is required to recover from this condition. |
| go-crypto-winnative Go crypto backend for Windows using Cryptography API: Next Generation (CNG). Prior to commit f49c8e1379ea4b147d5bff1b3be5b0ff45792e41, calls to `cng.TLS1PRF` don't release the key handle, producing a small memory leak every time. Commit f49c8e1379ea4b147d5bff1b3be5b0ff45792e41 contains a fix for the issue. The fix is included in versions 1.23.6-2 and 1.22.12-2 of the Microsoft build of go, as well as in the pseudoversion 0.0.0-20250211154640-f49c8e1379ea of the `github.com/microsoft/go-crypto-winnative` Go package. |
