| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| An inapplicable NSEC record may be accepted by a `named` resolver as proof that no wildcard exists, which could allow an attacker at the same or an upstream level of the zone name to mask the existence of a victim's wildcard record.
This issue affects BIND 9 versions 9.11.0 through 9.18.50, 9.20.0 through 9.20.27, 9.21.0 through 9.21.25, 9.11.3-S1 through 9.18.50-S1, and 9.20.9-S1 through 9.20.27-S1. |
| Improper input validation in Omnibox in Google Chrome prior to 152.0.7977.75 allowed a remote attacker leveraging social engineering to bypass web origin policy via crafted network traffic. (Chromium security severity: High) |
| Incorrect authorization in WebXR in Google Chrome prior to 152.0.7977.65 allowed a remote attacker leveraging social engineering to obtain cross-origin data via a crafted HTML page. (Chromium security severity: Medium) |
| The VeloCloud Edge software update workflow may accept update bundles without properly validating their signatures because the workflow does not restrict the digest algorithm used for artifact verification. An attacker with either sufficient privileges to upload packages to VeloCloud Orchestrator or credentials permitting direct access to an Edge may be able to install unauthorized software. |
| On affected platforms running Arista EOS with MLAG Dual Primary Detection configured, an unauthenticated attacker with access to the Dual Primary Detection network segment can send specially crafted packets to interfere with the dual-primary state. If the MLAG primary switch fails while these packets are present, the secondary switch incorrectly concludes it is in a dual-primary condition and err-disables its interfaces, leading to a traffic interruption. |
| For a secondary zone with transfers restricted by TSIG, `named` may start to serve the data provided in a zone transfer before the final message with the TSIG signature arrives. This could allow an attacker that does not actually possess a valid TSIG signature to send unauthorized zone contents to a secondary server. Although no TSIG signature ever arrives, `named` does not rollback to the pre-transfer state. To exploit the vulnerability, the transfer must be a multi-message TCP IXFR, as described by RFC 8945.
This issue affects BIND 9 versions 9.11.0 through 9.18.50, 9.20.0 through 9.20.27, 9.21.0 through 9.21.25, 9.11.3-S1 through 9.18.50-S1, and 9.20.9-S1 through 9.20.27-S1. |
| A flaw was found in Samba’s certificate auto-enrollment Group Policy handling. When certificate auto-enrollment is enabled, Samba may retrieve a CA certificate over an unencrypted HTTP connection and install it into the local trust store without proper verification. An attacker with the ability to intercept or redirect network traffic could exploit this behavior to supply a malicious certificate authority certificate, potentially allowing interception or spoofing of trusted communications. |
| MikroTik RouterOS accepts malformed RSA/PKCS#1 v1.5 signatures across RSA-based services, including TLS/X.509 certificate validation and SSH host-key authentication. Because its trust store includes an e=3 root CA, an attacker controlling or redirecting an outbound RouterOS TLS connection can use the root’s public certificate - without its private key - to forge a trusted intermediate and issue certificates for arbitrary hostnames, enabling TLS server impersonation. The same permissive verification also undermines RSA-based SSH authentication.
This issue affects only 7.x branch was fixed in versions: 7.23.6 (Long-term) and 7.24.3 (Stable).
Releases 7.23.4 and 7.24.2 included an incomplete fix. |
| The Robokassa payment gateway for Woocommerce WordPress plugin before 1.8.9 does not verify the authenticity of incoming payment notifications when its non-default deferred-payment feature is enabled, allowing unauthenticated attackers to forge a notification and mark arbitrary WooCommerce orders as paid or on-hold without payment or a valid signature. |
| undici 8.10.0 omits the destination origin from the cache and request-deduplication keys when the cache or deduplicate interceptor is composed directly onto a Client or Pool. Because the internal cache key falls back to an empty origin string, a cacheable or in-flight response from one upstream origin is returned for a request to a different, trusted origin whenever the method, path, and relevant headers match, which permits cross-origin information disclosure and persistent cache poisoning. The reporter demonstrated a full authentication bypass in which a JWT signed with an attacker-controlled key was accepted as belonging to a trusted issuer, and the trusted origin was never contacted. This is a regression introduced in 8.10.0 and affects undici versions from 8.10.0 up to 8.10.2. Applications using an Agent, which carries the origin in its dispatch options, are not affected. Users should upgrade to undici 8.10.2. |
| Improper verification of cryptographic signature in Windows RDP Client allows an unauthorized attacker to disclose information over a network. |
| Improper verification of cryptographic signature in Skype for Business allows an unauthorized attacker to perform spoofing over an adjacent network. |
| On affected platforms running Arista EOS with Dynamic Host Configuration Protocol (DHCP) relay configured, an unauthenticated attacker with network access could send a crafted DHCP reply packet from an IP address that is not configured as a helper address, and the relay agent would forward it to clients without validating the source. This could allow the attacker to supply clients with malicious network configuration parameters, potentially resulting in traffic interception or denial of service for affected clients. |
| PraisonAI is a multi-agent teams system. From praisonaiagents 0.6.0 until 1.6.59 and PraisonAI 3.10.0 until 4.6.59, ToolsMCPServer.run_sse() in src/praisonai-agents/praisonaiagents/mcp/mcp_server.py mounts SseServerTransport on the legacy /sse and /messages/ endpoints without default Host, Origin, or authentication enforcement. A malicious website can use DNS rebinding against a reachable local or internal SSE server, supply attacker-controlled Host and Origin headers, enumerate registered tools, and invoke them with the server user's privileges. The Streamable HTTP transport rejects the same hostile Origin, which isolates the flaw to the legacy SSE wrapper. An initial remediation was released in praisonaiagents 1.6.59 and PraisonAI 4.6.59. |
| Dell SCG 5.0 Appliance versions prior to 5.36.00.16 and Dell SCG 5.0 Application versions prior to 5.36.00.00, contains an Improper Verification of Cryptographic Signature vulnerability. An unauthenticated attacker with remote access could potentially exploit this vulnerability, leading to protection mechanism bypass. |
| dbt-mcp is a Model Context Protocol server for interacting with dbt. Prior to 1.20.0, the local OAuth helper in src/dbt_mcp/oauth/fastapi_app.py exposes GET /dbt_platform_context without authentication or Host validation after a user completes the dbt Platform OAuth flow. The endpoint returns the full DbtPlatformContext, including access_token and refresh_token values persisted by the context manager, to any process that can reach 127.0.0.1:6785. The absence of TrustedHostMiddleware allows a remote attacker to use DNS rebinding against a victim's browser because the helper accepts arbitrary Host headers, while a co-located process can request the endpoint directly. The stolen tokens provide immediate dbt Platform API access as the victim and persistent access through the refresh token, allowing access to or modification of projects, jobs, environment secrets, and related account data. This issue is fixed in version 1.20.0. |
| A security flaw has been discovered in ag-ui-protocol ag-ui 0.3.0. The affected element is the function create_strands_app of the file integrations/aws-strands/python/src/ag_ui_strands/utils.py of the component CORSMiddleware. The manipulation results in permissive cross-domain policy with untrusted domains. The attack may be launched remotely. The attack requires a high level of complexity. The exploitability is described as difficult. Upgrading to version AGUI.Abstractions@0.0.6 is sufficient to fix this issue. The patch is identified as 9b143b9668fa52c2054ede9d34a45ac4b4401089. It is suggested to upgrade the affected component. |
| A weakness has been identified in ag-ui-protocol ag-ui 1.0. The impacted element is the function prepareRunAgentInput of the file agent/agent.ts of the component Event Application Layer. This manipulation of the argument TEXT_MESSAGE_START causes origin validation error. Remote exploitation of the attack is possible. The pull request to fix this issue awaits acceptance. |
| Forgejo 13.0.0 through 16.0.4, when "[federation] ENABLED = true" is set, has a spoofing issue that affects identity integrity but does not allow account takeover or content modification. It does not verify that the HTTP Signature on an incoming ActivityPub activity was produced by the key belonging to the actor named in the activity body. The signature verification in routers/api/v1/activitypub/reqsignature.go validates the request signature, but the inbox activity handlers subsequently read the acting identity from the attacker-controlled JSON body without binding it to the verified signing key. Additionally, the signed Digest header is not recomputed against the received request body. A remote attacker who hosts a single valid ActivityPub actor and keypair can therefore submit signature-valid activities attributed to any actor identity they name. |
| MySQL MCP Server is a Model Context Protocol server that enables secure interaction with MySQL databases. Prior to 0.4.2, setting MCP_TRANSPORT=sse causes src/mysql_mcp_server/server.py to construct SseServerTransport without security_settings or enable_dns_rebinding_protection, while the Starlette routes /, /sse, and /messages/ have no authentication and the service binds to 0.0.0.0 by default. A network attacker can directly reach execute_sql, or can use DNS rebinding to make a victim's browser relay same-origin requests to a locally bound service, and supply a query that reaches cursor.execute(query). This allows unauthenticated disclosure and modification of the configured database; when the MySQL account has FILE privileges, the same access can read or write server files and may enable code execution. The default stdio transport is not affected. This issue is fixed in 0.4.2. |
