| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
bpf: NUL-terminate replaced sysctl value
When writing to sysctls, proc_sys_call_handler() guarantees that the
buffer passed to proc handlers is NUL-terminated. If
bpf_sysctl_set_new_value() replaces the pending sysctl value, it can
hand a replacement buffer directly to proc handlers. However, the
helper currently copies only buf_len bytes into that buffer without
appending a NUL terminator, leaving downstream parsers vulnerable to
out-of-bounds access.
Fix this by appending a '\0' after the replaced value to restore the
expected sysctl semantics. Since the helper already rejects buf_len
greater than PAGE_SIZE - 1, there is always room for the extra byte.
Reproduced in a QEMU x86_64 guest booted with KASAN while exercising
the sysctl replacement path with a cgroup/sysctl BPF program. The
reproducer targets `/proc/sys/net/core/flow_limit_cpu_bitmap`, fills
the original user write buffer with non-zero bytes, and overrides the
sysctl value so the replacement buffer lacks a terminating NUL. Under
that setup, the pre-fix kernel reported:
BUG: KASAN: slab-out-of-bounds in strnchrnul+0x72/0x90
Read of size 1 at addr ffff88800de57000 by task repro_patch3/66
CPU: 0 UID: 0 PID: 66 Comm: repro_patch3 Not tainted 7.1.0-rc3-00269-g8370ca1f87cc #6 PREEMPT(lazy)
Hardware name: QEMU Standard PC (i440FX + PIIX, 1996), BIOS 1.15.0-1 04/01/2014
Call Trace:
<TASK>
dump_stack_lvl+0x68/0xa0
print_report+0xcb/0x5e0
? __virt_addr_valid+0x21d/0x3f0
? strnchrnul+0x72/0x90
? strnchrnul+0x72/0x90
kasan_report+0xca/0x100
? strnchrnul+0x72/0x90
strnchrnul+0x72/0x90
bitmap_parse+0x37/0x2e0
flow_limit_cpu_sysctl+0xc6/0x840
? __pfx_flow_limit_cpu_sysctl+0x10/0x10
? __kvmalloc_node_noprof+0x5ba/0x870
proc_sys_call_handler+0x31d/0x480
? __pfx_proc_sys_call_handler+0x10/0x10
? selinux_file_permission+0x39f/0x500
? lock_is_held_type+0x9e/0x120
vfs_write+0x98e/0x1000
...
</TASK>
The buggy address is located 0 bytes to the right of
allocated 4096-byte region [ffff88800de56000, ffff88800de57000)
With this fix applied, rerunning the same sysctl-targeted path yields
no corresponding KASAN reports. |
| In the Linux kernel, the following vulnerability has been resolved:
dpaa2-switch: rework FDB management on the bridge leave path
On bridge leave, the dpaa2_switch_port_set_fdb() function always
allocates a new FDB for the port which is becoming standalone. In case
no FDB is found, then the port leaving a bridge will continue to use the
current one.
The above logic does not cover the case in which there are multiple
bridges which have ports from the same DPSW instance. In this case, when
the last port leaves bridge #1, it finds an unused FDB to switch to, but
the old FDB is not marked as unused. Since the number of FDBs is equal
to the number of DPSW interfaces, this will eventually lead to multiple
ports sharing the same FDB.
Fix this by changing how we are managing the FDBs on the leave path.
Instead of directly allocating a new FDB, first verify if the current
port is the last one to leave a bridge. If this is the case, then
continue to use the current FDB and only allocate another FDB if there
are other ports remaining in the bridge. |
| In the Linux kernel, the following vulnerability has been resolved:
ACPICA: Add package limit checks in parser functions
Add package limit checks in parser functions to prevent out-of-bounds
access. |
| In the Linux kernel, the following vulnerability has been resolved:
hpfs: handle set_blocksize failures
hpfs uses buffer_heads, which don't handle block size > PAGE_SIZE well.
Without this, mounting will hit the
BUG_ON(offset >= folio_size(folio));
in folio_set_bh on the first __bread_gfp call. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu: validate and share PSP fw_pri_buf copies via psp_copy_fw
Change psp_copy_fw from void to int: return -ENODEV when drm_dev_enter
fails, and -EINVAL when the image size is zero or larger than the
1 MiB PSP private buffer.
Replace open-coded memset/memcpy into fw_pri_buf with psp_copy_fw. |
| In the Linux kernel, the following vulnerability has been resolved:
PCI/sysfs: Add CAP_SYS_ADMIN check to __resource_resize_store()
Currently, the __resource_resize_store() allows writing to the
resourceN_resize sysfs attribute to change a BAR's size without checking
for capabilities, currently relying only on the file access check.
Resizing a BAR modifies PCI device configuration and can disrupt active
drivers. After the upcoming conversion to static attributes, it will also
trigger resource file updates via sysfs_update_groups().
Add a CAP_SYS_ADMIN check to prevent unprivileged users from performing BAR
resize operations. |
| A flaw was found in CRI-O. The fix for a previous vulnerability (CVE-2022-4318) was incorrect, allowing it to be bypassed. An attacker capable of setting environment variables on a container can inject a newline character into the HOME environment variable. This issue allows the addition of arbitrary lines into /etc/passwd by use of a specially crafted environment variable. |
| Lemonldap::NG::Portal versions from 2.23.0 before 2.23.4 for Perl allow a PKCE bypass for public Relying Parties in "PKCE or secret" mode because checkEndPointAuthenticationCredentials does not verify the client secret.
With oidcRPMetaDataOptionsRequirePKCE set to 2, the authorization endpoint issues a code even when the request carries no code_challenge, and token() admits the exchange as long as a challenge was stored or an authentication method was returned for the caller. checkEndPointAuthenticationCredentials() skips the secret comparison for a Relying Party marked public and still returns the method deduced from the request, so any Basic or form credential satisfies the secret branch. validatePKCEChallenge() then passes, because neither a challenge nor a verifier is present.
An attacker who intercepts an authorization code issued to a public Relying Party can exchange it for the user's access, ID and refresh tokens by replaying the client_id with an arbitrary secret, which is the attack PKCE prevents. Dynamic client registration creates every Relying Party in this mode. |
| In the Linux kernel, the following vulnerability has been resolved:
spi: core: Abort active target transfer on controller suspend
When an SPI controller operating in target mode has a transfer in
progress at the time of system suspend, the suspend path proceeds
without aborting the ongoing transfer. This can leave the hardware in
an inconsistent state, potentially causing the system to hang or fail
to resume cleanly.
Fix this by invoking the controller's target_abort callback from
spi_controller_suspend() when the controller is in target mode and the
callback is registered. This ensures any active target transfer is
cleanly terminated before the controller is suspended. |
| In the Linux kernel, the following vulnerability has been resolved:
net: ibm: emac: mal: fix potential system hang in mal_remove()
napi_disable() is not idempotent and calling it on an already-disabled
or unenabled NAPI context will cause the kernel to spin indefinitely
waiting for the NAPI_STATE_SCHED bit to clear.
In mal_remove(), napi_disable() is called unconditionally. If no MACs were
registered, NAPI was never enabled. Also, if they were registered but
subsequently unregistered, NAPI was already disabled in
mal_unregister_commac(). In either case, calling napi_disable() causes
the kernel to hang upon module removal.
Fix this by only calling napi_disable() in mal_remove() if the commac list
is not empty (which implies NAPI is enabled). |
| Velociraptor contains a deadlock condition that may be triggered by authenticated users. The issue stems from a lock management bug in the user management module. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amd/pm: bound pp_dpm_set_pp_table() memcpy
The powerplay path allocates hardcode_pp_table once with kmemdup(...,
soft_pp_table_size). memcpy(..., size) used the sysfs store count (up to
PAGE_SIZE) with no upper bound, causing heap overflow. Reject
writes where size exceeds soft_pp_table_size. |
| In the Linux kernel, the following vulnerability has been resolved:
xhci: Prevent queuing new commands if xhci is inaccessible
Refuse to queue a new command on the command ring if xHC is marked
inaccessible with the HCD_FLAG_HW_ACCESSIBLE.
HCD_FLAG_HW_ACCESSIBLE is set and cleared in suspend and resume.
Also print a warning if xhci is being suspended with commands
still pending on the command ring. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: Avoid DPMS-on for phantom stream
[Why & How]
Calling dc_update_planes_and_stream separately for stream and its
phantom stream causes a NULL pointer dereference, since the phantom is
destroyed on the first call.
Skip the call for phantom streams. |
| In the Linux kernel, the following vulnerability has been resolved:
ata: ahci: fail probe if BAR too small for claimed ports
When an AHCI controller is disabled in BIOS, its HOST_CAP register may
contain a bogus value, e.g. 0xFFFFFFFF.
Since CAP.NP (Number of Ports) is a zeroes based 5-bit register field,
a value of 0x1f means 32 ports. If CAP.NP claims more ports than can
physically fit within the mapped BAR region, accessing port registers
beyond the BAR boundary causes a kernel panic.
Add validation in ahci_init_one() to check that the BAR size is
sufficient for the number of ports claimed in CAP.NP. The check
calculates the required MMIO size as:
required_size = 0x100 (global registers) + max_ports * 0x80
If required_size exceeds the actual BAR size, the probe fails with
-ENODEV, preventing the panic and providing a clear error message.
[cassel: commit log] |
| In the Linux kernel, the following vulnerability has been resolved:
ACPICA: Fix NULL pointer dereference in acpi_ns_custom_package()
acpi_ns_custom_package() unconditionally dereferences the first element
of the package to read the _BIX version number, without checking for
NULL:
if ((*Elements)->Common.Type != ACPI_TYPE_INTEGER)
When firmware returns a _BIX package whose first element is an
unresolvable reference, ACPICA evaluates that entry to NULL.
acpi_ns_remove_null_elements() does not strip NULL entries for
ACPI_PTYPE_CUSTOM packages (fixed-position format would break if
elements were shifted), so acpi_ns_custom_package() sees the NULL
and causes a crash.
Add a NULL check for the first element (version field) before
dereferencing it. The caller then receives AE_AML_OPERAND_TYPE
instead of crashing. |
| CuteNews v.2.1.2 is vulnerable to Server-Side Request Forgery (SSRF) in core/modules/media.php -- upload_from_inet (Media Manager's "Upload by URL" functionality). |
| Stencil core 4.43.5 contains a DOM-based cross-site scripting (XSS) vulnerability in the component runtime. When a downstream application enables the experimental slot fixes option and uses scoped components, assigning a string to the textContent property of such a component's host element causes the value to be parsed as HTML instead of being inserted as text. If an application writes attacker-controlled data to these host elements, the data can be interpreted as markup and script can execute in the context of the application's origin. |
| In the Linux kernel, the following vulnerability has been resolved:
ACPICA: Fix condition check in acpi_ps_parse_loop()
Fix condition check for AML_ELSE_OP in acpi_ps_parse_loop() to prevent
out-of-bounds access. |
| In the Linux kernel, the following vulnerability has been resolved:
usb: gadget: goku_udc: avoid NULL deref of dev->driver in INT_USBRESET log
goku_irq() handles a number of bus events under a single ep0 path.
It already guards the gadget driver suspend/resume callbacks against a
NULL ->driver:
if (dev->gadget.speed != USB_SPEED_UNKNOWN
&& dev->driver
&& dev->driver->resume) {
spin_unlock(&dev->lock);
dev->driver->resume(&dev->gadget);
...
}
but the very next branch unconditionally dereferences dev->driver
when an INT_USBRESET arrives:
if (stat & INT_USBRESET) {
ACK(INT_USBRESET);
INFO(dev, "USB reset done, gadget %s\n",
dev->driver->driver.name);
}
If the controller raises INT_USBRESET before any gadget driver has
been bound (or after one has been unbound), dev->driver is NULL and
the printk dereferences NULL.
smatch flags the inconsistency:
drivers/usb/gadget/udc/goku_udc.c:1618 goku_irq() error:
we previously assumed 'dev->driver' could be null (see line 1607)
Fall back to a placeholder when the gadget driver is not bound.
No functional change while a gadget driver is bound. |
