| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| Sandbox escape due to race condition in the XPConnect component. This vulnerability was fixed in Firefox 156 and Thunderbird 156. |
| In the Linux kernel, the following vulnerability has been resolved:
ipv6: avoid divide by zero in rt6_multipath_rebalance
rt6_multipath_rebalance() calculates the total eligible nexthop weight
in one pass and programs upper bounds in a second pass. Since
RTM_NEWROUTE is RTNL-free, a concurrent
ignore_routes_with_linkdown update can make the first pass return zero
while the second sees an eligible nexthop, causing
rt6_upper_bound_set() to divide by zero.
UBSAN: division-overflow in net/ipv6/route.c:4845:17
Oops: divide error: 0000 [#1] SMP KASAN NOPTI
rt6_upper_bound_set() net/ipv6/route.c:4845
rt6_multipath_rebalance()
fib6_add_rt2node()
ip6_route_multipath_add()
inet6_rtm_newroute()
Skip upper-bound calculation when the first pass reports a zero total.
This respects the lock-free performance considerations here and solves
insecure scenarios. |
| In the Linux kernel, the following vulnerability has been resolved:
ptp: netc: fix period truncation and potential divide-by-zero in PEROUT
The max_period bound in net_timer_enable_perout() was computed as:
max_period = (u64)NETC_TMR_DEFAULT_FIPER + integral_period;
which exceeds U32_MAX when integral_period > 0 (e.g. 0x100000002 for
the default 333333333 Hz clock). A period_ns that passes this check but
exceeds U32_MAX is then silently truncated when stored into the u32
struct netc_pp::period field.
A truncated value of zero can reach netc_timer_set_perout_alarm(), where
the local u32 period variable would also be 0, causing a divide-by-zero
in roundup_u64(delta, period) whenever the stime < min_time branch is
taken (which always happens for a start time of {0, 0}).
Additionally, netc_timer_enable_periodic_pulse() and
netc_timer_enable_fiper() both compute:
fiper = pp->period - integral_period;
A zero pp->period results in an unsigned wraparound to 0xFFFFFFFD,
mis-programming the FIPER hardware register.
Fix all three issues by capping max_period at NETC_TMR_DEFAULT_FIPER
(0xFFFFFFFF). This ensures that any period_ns passing the range check
fits in a u32 without truncation, so the stored value is always valid
and non-zero. The accepted range is reduced by integral_period ns
(typically only a few nanoseconds), which is negligible in practice. |
| In the Linux kernel, the following vulnerability has been resolved:
bpf: Disallow bpf_{g,s}etsockopt() in cgroup UNIX getname hooks
_bpf_setsockopt() and _bpf_getsockopt() call sock_owned_by_me() for
full sockets, so these helpers expect the socket lock to be held.
BPF_CGROUP_UNIX_GETPEERNAME and BPF_CGROUP_UNIX_GETSOCKNAME run BPF
programs without acquiring the socket lock. A program attached to
either hook can therefore trigger the sock_owned_by_me() warning by
calling bpf_setsockopt() or bpf_getsockopt().
Disallow bpf_setsockopt() and bpf_getsockopt() for CGROUP_UNIX_GETPEERNAME
and CGROUP_UNIX_GETSOCKNAME. |
| In the Linux kernel, the following vulnerability has been resolved:
mailbox: qcom-cpucp: fix PREEMPT_RT self-deadlock in IRQ handler
qcom_cpucp_mbox_irq_fn() calls mbox_chan_received_data() while holding
chan->lock. Under PREEMPT_RT, spin_lock_irqsave() is converted to an
rt_spinlock (rtmutex-based), which tracks ownership and can sleep.
The callback chain triggered by mbox_chan_received_data() eventually
reaches mailbox_clear_channel() -> mbox_send_message() -> add_to_rbuf(),
which attempts to re-acquire the same chan->lock. Since rtmutex detects
the re-entrant lock attempt by the same owner, the thread blocks waiting
for a lock it already holds, causing a permanent deadlock.
This deadlock manifests as 'irq/N-apss_cpucp_mbox' stuck in D state
with the following call trace:
rt_spin_lock -> mbox_send_message -> mailbox_clear_channel ->
scmi_rx_callback -> mbox_chan_received_data [<- held chan->lock here]
Fix by saving chan->cl locally and clearing the HW interrupt register
inside the lock, then invoking mbox_chan_received_data() after releasing
the lock. This preserves the mutual exclusion for chan->cl access while
avoiding the lock re-entrancy that causes the PREEMPT_RT deadlock. |
| In the Linux kernel, the following vulnerability has been resolved:
md: recheck spare changes before starting sync
remove_spares() and remove_and_add_spares() modify the array's rdev
configuration. These operations are only safe after the array has been
suspended.
md_start_sync() checks whether spare configuration changes are needed
before taking reconfig_mutex. However, the rdev state can change before
the mutex is acquired, so the initial check can become stale. In that
case, md_choose_sync_action() may remove or replace rdevs while normal
I/O is still accessing them.
The race can occur as follows:
raid10d Worker Normal IO
____________ _______________________ ______________________
raid10_write_request()
wait_blocked_dev()
set Blocked
set Faulty
Skip Faulty rdev
rrdev->nr_pending++
.repl_bio = bio
removeable_rdev = false .
array not suspended .
lock mddev goto err_handle
lock mddev (wait)
.
update sb .
clear Blocked .
.
unlock mddev .
lock mddev (acquires)
remove_spares()
removeable_rdev = true
raid10_remove_disk()
rdev = replacement
replacement = NULL
rdev_dec_pending(NULL)
unlock mddev (NULL)->nr_pending--
In this case, rdev_dec_pending() is called with a NULL pointer,
resulting in a NULL pointer dereference when attempting to decrement
nr_pending.
Fix this by suspending the array when spare configuration changes are
needed, including for non-read-write arrays, and checking again after
taking reconfig_mutex. If the array was not already suspended and a
change is now needed, release the mutex, suspend the array, and
reacquire the mutex before continuing. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: iwlwifi: guard against division by zero in iwl_dbg_tlv_alloc_fragments
Make sure we don't end-up with a num_frags = 0 situation.
For that, check that the required size is not 0 and put a checker on
num_frags as well. |
| In the Linux kernel, the following vulnerability has been resolved:
crypto: rk3288 - fail ahash requests on HASH idle timeout
rk_hash_run() waits for RK_CRYPTO_HASH_STS to become idle after the
final DMA transfer, but ignores the poll result. If the hash engine
never becomes idle, the driver still reads the digest registers and
finalizes the request with the previous success value.
Store the poll result and finalize the request with the timeout error
before reading the digest registers. |
| In the Linux kernel, the following vulnerability has been resolved:
dmaengine: dw-edma: Serialize abort state updates
dw_edma_abort_interrupt() drops vc.lock before changing request and
status. issue_pending() can acquire the lock in that small window,
observe the old busy state, and skip starting queued descriptors. Then
the abort handler overwrites the channel status as idle, leaving the new
descriptors stranded for good.
Keep descriptor completion and the state transition in the same critical
section. |
| In the Linux kernel, the following vulnerability has been resolved:
HID: asus: refactor the two workqueues and init sequence
Multiple issues have been found within the hid-asus driver:
- unchecked size in asus_raw_event()
- unclean teardown of asus_probe on failure
- possible use-after-free in asus_probe
- multiple workqueue used for jobs where one was enough
- sleeping calls in atomic context
- packets of incorrect size being sent to the keyboard controller
Join the two workqueues into one reusing the stopping mechanism
of the brightness workqueue, use the joined workqueue to also
move the asus_wmi_send_event() sleeping call away from atomic
context and add a size check in asus_raw_event(). |
| In the Linux kernel, the following vulnerability has been resolved:
iio: chemical: atlas-sensor: fix PM reference leak in buffer postenable
atlas_buffer_postenable() acquires a runtime PM reference with
pm_runtime_resume_and_get() but returns the result of
atlas_set_interrupt() directly. If atlas_set_interrupt() fails,
the runtime PM reference is leaked and the device can never
autosuspend.
Add pm_runtime_put_autosuspend() on the error path to balance
the reference. |
| Race condition in Core in Google Chrome on on Windows prior to 152.0.7977.65 allowed a remote attacker leveraging social engineering to bypass web origin policy via a crafted HTML page. (Chromium security severity: Low) |
| Race condition in Extensions in Google Chrome on on Mac prior to 153.0.8010.47 allowed a remote attacker who had compromised the renderer process and leveraged social engineering to potentially execute arbitrary code outside the sandbox via UI Interaction. (Chromium security severity: High) |
| Privilege escalation in the DevTools component. This vulnerability was fixed in Firefox 156, Firefox ESR 153.3, Thunderbird 156, and Thunderbird 153.3. |
| Race condition in Network in Google Chrome prior to 153.0.8010.47 allowed a remote attacker who had compromised the renderer process to obtain cross-origin data via a crafted HTML page. (Chromium security severity: High) |
| Race condition in V8 in Google Chrome prior to 151.0.7922.173 allowed a remote attacker to execute arbitrary code inside the sandbox via a crafted HTML page. (Chromium security severity: High) |
| Race condition in USB in Google Chrome prior to 151.0.7922.169 allowed a remote attacker who had compromised the renderer process to potentially execute arbitrary code outside the sandbox via a crafted HTML page. (Chromium security severity: High) |
| In the Linux kernel, the following vulnerability has been resolved:
userfaultfd: gate must_wait writability check on pte_present()
userfaultfd_must_wait() and userfaultfd_huge_must_wait() read the PTE
without taking the page table lock and then apply pte_write() /
huge_pte_write() to it. Those accessors decode bits from the present
encoding only; on a swap or migration entry they read the offset bits that
happen to share the same position and return an undefined result.
The intent of the check is "is this fault still WP-blocked?". A
non-marker swap entry means the page is in transit -- the userfault
context the original fault delivered against is no longer the same, and
the swap-in or migration completion path will re-deliver a fresh fault if
userspace still needs to handle it. Worst case under the current code the
garbage write bit says "wait", and the thread stays asleep until a
UFFDIO_WAKE that may never arrive.
Gate the writability check on pte_present() so the lockless re-check only
inspects present-PTE bits when the entry is actually present. The
non-present, non-marker case returns "don't wait" and lets the fault path
retry. |
| In the Linux kernel, the following vulnerability has been resolved:
net: mana: Fix race on per-CQ variable napi work_done
After calling napi_complete_done(), the NAPIF_STATE_SCHED bit may be
cleared, and another CPU can start napi thread and access per-CQ variable,
cq->work_done. If the other thread (for example, from busy_poll) sets
it to a value >= budget, this thread will continue to run when it should
stop, and cause memory corruption and panic.
To fix this issue, save the per-CQ work_done variable in a local variable
before napi_complete_done(), so it won't be corrupted by a possible
concurrent thread after napi_complete_done().
Also, add a flag bit to advertise to the NIC firmware: the NAPI work_done
variable race is fixed, so the driver is able to reliably support features
like busy_poll. |
| Inappropriate implementation in Passwords in Google Chrome prior to 151.0.7922.72 allowed a remote attacker who had compromised the renderer process to leak cross-origin data via a crafted HTML page. (Chromium security severity: Low) |
