Search
Search Results (3 CVEs found)
| CVE | Vendors | Products | Updated | CVSS v3.1 |
|---|---|---|---|---|
| CVE-2026-90124 | 1 Linux | 1 Linux Kernel | 2026-09-20 | N/A |
| In the Linux kernel, the following vulnerability has been resolved: irqchip/renesas-rzg2l: Fix loss of interrupt rzg2l_clear_irq_int() and rzg2l_clear_tint_int() perform a read-modify-write on the ISCR/TSCR status registers to clear the bit for the interrupt just handled. Since these registers are write-0-to-clear per bit, this is racy: If another interrupt's status bit gets set between the read and the write, that bit is written back as 0 by the software-constructed value, clearing an interrupt that hasn't been serviced yet and losing it. This can be reproduced by triggering multiple interrupts at once, e.g.: gpioset -c gpiochip0 355=0 353=0 328=0 352=0 Fix this by writing back only the bit being cleared, with all other bits set to 1, instead of read-modify-writing the whole register. Since 1-bits are left unchanged by hardware, concurrently-set status bits for other interrupts are preserved. | ||||
| CVE-2026-90208 | 1 Linux | 1 Linux Kernel | 2026-09-19 | N/A |
| In the Linux kernel, the following vulnerability has been resolved: clocksource/drivers/samsung_pwm: Switch to raw_spinlock_t type Samsung PWM timer might be used as a clock source on some legacy systems. When PREEMPT_RT is enabled on ARM, regular spinlock is converted to a sleeping lock (mutex-based), which must not be used in atomic context such as hard interrupt handlers. Switch the samsung_pwm_lock to the raw_spinlock, which remains a true non-sleeping spinlock even under PREEMPT_RT. | ||||
| CVE-2026-89850 | 1 Linux | 1 Linux Kernel | 2026-09-18 | N/A |
| In the Linux kernel, the following vulnerability has been resolved: scsi: qla2xxx: Don't query firmware state while chip is down qla2x00_fw_state_show() initializes rval to QLA_FUNCTION_FAILED and jumps to the out: label when the chip is down or EEH is busy. The out: block then re-issued qla2x00_get_firmware_state() because rval != QLA_SUCCESS, defeating the chip-down/EEH-busy guards and issuing a mailbox command (outside optrom_mutex) during ISP reset or PCI error recovery, which can hang the adapter. It also turned a normal in-lock mailbox failure into a second unsynchronized mailbox attempt. Make the out: fallback only mark the firmware state as unknown. The mailbox is now issued at most once, inside optrom_mutex, and only when the chip is up and not EEH-busy. | ||||
Page 1 of 1.